Setup |
 |
| TITLE |
+ |
- |
| FILE NAME |
+ |
- |
| DATE |
+ |
- |
| POSITION |
+ |
- |
|
|
self launch1202 viewsside view of the kite as you walk back, notice how the sand is keeping it from sliding
|
|
self launch995 viewsbar hard right, you begin to walk back into the wind. Very important your back into the wind
|
|
954 viewsfront view of sand behind leading edge, ready to launch
|
|
self launch862 viewswalk back with the bar hard right[this is because you want the kite to relaunch left, always is oposite] until the kite moves
|
|
self launch803 viewsback view of kite rolling as the rider steps foward
|
|
self launch853 viewskite is ready for launch, takes flight and you push out on bar, depower and control as you walk towards the water. i have found is better to walk towards the water with the kite at an angle. This is beter then at 12 or nuetral. lessons the chance to get lofted and with the kite to the side a bit if you let go of the bar, it goes down fast and no power
|
|
a look at the sprint valves593 views
|
|
hose clamp398 viewsthese clamps work very well, and even when you slam the kite on the water they stay closed. safter you pump up the kite, you need to close these valves
|
|
clamps357 viewsclamps have stainless steel screws that are a number 1 phillips screw driver.They have guides that slide along the valve to help it stay in place.
|
|
taking off310 viewsit comes off to replace strut..side not keep collar aside when changing strut or you will lose it
|
|
sprint system has collar over hose259 viewsthis collar slides of the hose to secure to valve
|
|
235 views
|
|
put slip knot on valve and pull out through bottom240 views
|
|
203 views
|
|
make sure bladder is folded corect before pulling through243 views
|
|
make a slip knot to pull the bladder through217 views
|
|
204 views
|
|
224 views
|
|
174 views
|
|
186 views
|
|
|
|
Login